f polyurethane slurry pump system

Dirty water pump Jabsco 24V 7.6/8.9Amp

Cutting pump 24V Jabsco

Model 18590-2094

Self Priming

Macerator Pump

With Dry Protection

Features

Pump: self-priming flexible impeller with Wear plate made of stainless steel Impeller: Jabsco Nitrile compound

Information about the pump:

New Model 18590-2094

Macerator: stainless steel cutter reduces particle size up to 3 mm. New 4 blade design.

Seal: Lip Type Ports: Inlet - 1-1 / 2 "(38mm) hose tail and 1-1 / 2 "N.P.T. (male) Exhaust - 1 "(25mm) hose tail

NEW Model 18590-2094

Motor: permanent magnet type, complete Enclosed, with stainless steel shaft Including dry-running protection that switches off the pump. Powder coated housing with sealed end bells and bearings. Complies with USCG regulation 183,410 and ISO 8846 MARINE for Ignition protection.

Weight: 5 lb (2.3 kg) Approx.

SPECIFICATION

Model 18590-2094 Priming - 5ft when wet 4ft when dry

MAIN CAPACITY AND FLOW RATES

AMPS Delivery head Meter GPM Liter 12 Volt 24 Volt 0 0 12.5 47 14.0 7.6 5 1.5 11.5 44 14.5 7.8 10 3 10.5 40 15.0 8.1 15 4.5 9.0 34 16.0 8.6 20 6 7.5 28 16.5 8.9 Flow rate and amperage will vary slightly depending on loading pump (design sanitary system).

VARIATIONS AVAILABLE

MODEL NO. DESCRIPTION 18590-2092 12 Volt EMC 18590-2094 24 Volt EMC

Grinding capacities - able to reduce waste up to a particle size of max. 1/8 "(3 mm) Able to pass on waste, toilet paper, facial tissues, cigarettes, cigars, pieces soft fruits or vegetables less than 2.5 cm, fish scales, or bait residue. Not designed to pass fruit kernels, rags, wet strength kitchen towels, tampons or sanitary napkins.

APPLICATIONS

Model 18590-2094

WASTE DISPOSAL

The Jabsco 18590 series DC grinder pump unit is the ideal solution for emptying sea tanks when not in a discharge restricted area. Self-priming up to 1.5 meters this pump will empty a typical capacity of 115 liters (30 gallons) refuel in less than 3 minutes. Duty cycle of the pump is 15 minutes continuously, which means a 180 gallon (680 liters) can be emptied in one operation It is recommended that recovery tanks are flushed several liters of water after each pump. This will reduce the possibility of sustained sediment build-up in the tank, which could cause a possible blockage.

FISHBOX AND LIVEWELL TANK EVACUATION

The Jabsco Macerator Pump is the ideal pump for the emptying fish box and live well bins. Very often the live well tank will be above the waterline of the boat, when this is the case, gravity can be used to determine the livewell tank. If not installed in this format, it is beneficial to use the Jabsco macerator pump for evacuation because of its self-priming properties and also the grinding properties.

APPLICATIONS

WASTE DISPOSAL

FISHBOX AND LIVEWELL TANK EVACUATION

Able to pass on waste, toilet paper, fish scales or bait residue. Not designed pass rags, kitchen towels, tampons, wet wipes or sanitary napkins.

Fishing boxes are usually placed in the floor of the vessel and are often located below the waterline or alone partially above the waterline. Again the Jabsco Macerator pump has the characteristics that lend itself to itself to this application. The bait remnants particles of ice, fish scales and everything else could possibly be found in the Fish-Box managed to buy the Jabsco Macerator Pump, and get it yourself The priming capabilities are perfect for fish box installations common to many of today's sport fishing boats.

GENERAL INSTALLATION SUGGESTIONS

The pump can be mounted in any direction without loss of performance. However, it is recommended that if the pump is mounted vertically than the pump head mounted under the motor (pump head pointing down) Use the supplied rubber grommets to absorb vibrations The Macerator pump can be placed directly in a 1-1 / 2 "(38 mm) NPT tank flange or female pipe fitting. If you need to attach the inlet port to a pipe fitting this may be necessary removing the hose tail port, this can be done with a hacksaw. Wrap gate wires with a few turns Teflon tape and screw the pump assembly into the tube appropriate. Hand tighten, not too tight.

Note: An air leak somewhere in the suction side of the plumbing system can cause prolonged drought run. All suction connections must be airtight and free from sharp bends

Description on article: Jabsco 24 volts Ignition Protected Motor Complies With USCG 183.410 and ISO 8846 Marine Made in Mexico S/N14I56793 74001-2597 24V USA UK Canada Germany Japan Italy

Description on packaging Pump Sealed Macerator HD 24CE S/N: 18B40297 Model: 18590-2094 Made in Mexico