the best vape brand

Vaping without battery! :)

Hi everyone!

So if you didn't know i used to have the following setup: eGo-T(900 mAh) with a tumbler tank with 1.8ohm coil. It had a couple of leaking issues but i felt it wasn't worth fixing. Anyway so i went to this party last friday and i brought the equipment with me I took a couple of beers and basicly it got stolen So i found this old CE4 clearomizer with some remaining liquid in it and im wondering: Is it possible to actually vape on it with the charger or with some 9 volt battery or something? that would be great as my new battery wont come in 2 weeks Thanks for reading! Cheers

I don't know if it would work very well.

Your typical USB output is 5V, much higher than you would usually vape at. You can get something like this, which is a USB based variable voltage non-battery based e-cig. Sorry to hear about the loss, that sucks. You might try a local shop if you have one...or at least order from somewhere that isn't two weeks away? Oh, and you should probably order TWO batteries.

3 dry cells will get ya 4.5 volts.

Find a switch n some wire. Add tape. Vape. Maybe

Hence everyone always saying have a back up!

I'm sorry to hear that it got stolen bud, People in this world can be more rotten than tomatoes nowadays. Definitely consider getting a backup

Sadly i live in sweden and in sweden the whole ecig thingy isn't very big so there are not a single shop based on ecig selling :/

but i think that USB thingy looks really cool! what is the shipping time though?

That's a big maybe, pimpin.

You don't have any other source of a hook up because setting up some backwoods still to vape on sounds like you're an anti-vaping article waiting to happen

Im just not sure where the wiring would go onto the clearomizer?

is there no tutorial out there maybe?

I've never owned an ego so not sure what the specs on the charger are but what I've done while waiting on my first mech mod in the mail was make a usb pass through.

All I did was cut the end of a usb cord off, add a switch and wire it to the atomizer of a disposable Ehookah "removed dead battery". Then just plugged it into a 5v 2600mah usb power pack "used for recharging cell phones". Worked great and you can also just use a usb wall charger if you don't have a power pack. If charger puts out at least 4.2v and 1-2 amps I would think it would work fine but a switch is recommended so you don't have to constantly plug/unplugg to vape. Hope this helps

Ya... im sick and tired of people wont letting others stuff be....

i do have usb wallcharger things and i do got switches, my only problem is where to wire on the clearomizer?

Poor dude is screwd.

I feel for him as I also am pretty much in a Vape dessert. Without backups, I would be outta luck also.

Please don't try to vape without the battery or make something to try.

unless you are an electrician, a engineer or educated electronics professional

One wire on the outside of the metal base, one on the center.

Trick is getting something with a voltage close and enough amperage.

Ever heard of knowing enough to be dangerous?

This is an after school special waiting to happen.

Many of the batteries we use are based on Remote Control hobbies.. check out those shops if you have any.. a good 3.7volt battery and an on/off switch work wonders!

Go to convience store and grab a disposable or a blu something along those lines so you can vape in the interim

Best advice right there.

Positive wire to center pin, negative to outer cone metal.

Or viceversa doesn't matter. First way is just how it is for use with the battery connector. If charger puts out enough amps 1-2 I'd just use that with a switch cause it has the connector and you won't have to solder to your attomizer. usb power pack for mobility and will last longer than your ego battery did

That sounds logical