4 clay dredge pump specs

Hydromatic Pump - Hydromatic S3WRD300M2-2 Submersible Sewage Pump 3 HP 230V 1PH Manual 20' Cord #HTC52799E130

Hydromatic S3WRD300M2-2 Submersible Wastewater Vortex Pumps Description

Strong cast iron vortex pump designed for residential raw sewage and light commercial applications.

Hydromatic S3WRD Typical Application

Residential Raw Sewage

Light Commercial Applications

Hydromatic S3WRD Superior Features

Recessed impeller design has completely open passage in volute

Operates without vibration or cavitation over entire performance curve; operates near shutoff without harming pump.

Recessed impeller greatly increases bearing life by reducing radial load

Oil-filled motor for maximum heat dissipation and constant bearing lubrication

Heat sensor thermostats embedded in windings protect motor from overheat conditions

Seal leak probes warn of moisture entry

Hydromatic S3WRD300M2-2 Specifications

BODY CONSTRUCTION: Class 30 Cast Iron; ASTM A48

HORSEPOWER: 3.0 HP

RPM: 3450

MAXIMUM HEAD: up to 51 ft. (15.6 m)

MAXIMUM CAPACITY: up to 240 GPM

SWITCH TYPE: Control Panel Required

MINIMUM SUMP DIAMETER: Duplex = 48" (1219.2 mm)

DISCHARGE PIPE SIZE: 3" (76.2 mm) Flanged Horizontal

MAXIMUM SOLIDS HANDLING SIZE: 2" (50.6 mm)

CORD LENGTH: 20' Standard

CORD SIZE: 12-3; Type: SOOW

START AMPS: 63.0 RUN AMPS: 19.0

VOLTAGE: 1ø, 230V, 60Hz

MAXIMUM LIQUID TEMPERATURE: 140°F (60°C)

MOTOR: Enclosed, Oil Cooled Induction

IMPELLER CONSTRUCTION: Ductile Iron; Class 65; ASTM A536

Hydromatic S3S200M2-4 Submersible Sewage pumps Description

Hydromatic S3S Submersible Sewage pumps are suited to wet-well installation in a wide variety of municipal, industrial and building trades applications.

Hydromatic S3S Typical Application

Municipal Sewage Lift Stations

Industrial Sewage Transfer

Dewatering of Storm Water

Hydromatic S3S Superior Features

Oil-Filled Motor for Cooler Operation, Longer Life, and Less Maintenance. The Dielectric Oil Effectively Dissipates Heat and Lubricates Upper and Lower Ball Bearings.

Single Phase Motors are Capacitor Start, Capacitor Run with Capacitors Located in Control Panel. Contact distributor for Proper Hydromatic Control Panel Sizing.

Standard Construction is Cast Iron.

300 Series Stainless Steel Shafts.

35' Power Cord has Three Conductor PVC Jacket.

Field Serviceable; Pumps have 300 Series Stainless Steel Fasteners for Easy Tear Down.

Semi-Open, Two-Vane Sewage Type Impellers have Pump-Out Vanes on Back Shrouds to Prevent Stringy Materials from Building up Around Shaft and Seal.

Manufactured with Carbon and Ceramic Faced Mechanical Shaft Seal for Long Leak Proof Life.

All Units Given Complete Hydraulic Test Run Before Shipping.