high pressure slurry pump house

China Customized Rubber Covered Pit Slurry Pump Manufacturers, Suppliers, Factory - Quotation - MIMO FLOW CONTROL

Rubber Covered Pit Slurry Pump

Structure description SP and SPR pumps are vertical centrifugal slurry pumps, which are immersed in liquid and used to transport abrasive, coarse particles and high-concentration slurry. There is no need for any shaft seal and shaft seal water, and it can work normally under the condition of...

Structure description

SP and SPR pumps are vertical centrifugal slurry pumps, which are immersed in liquid and used to transport abrasive, coarse particles and high-concentration slurry. There is no need for any shaft seal and shaft seal water, and it can work normally under the condition of insufficient suction. The pump body of SP pump is made of wear-resistant metal, and the impeller is made of wear-resistant metal, rubber or polyurethane material.

The parts of the SPR pump immersed in the liquid are lined with rubber. Suitable for conveying corrosive slurry.

Installation and use method of deep well submersible pump and submerged slurry pump

1. Acceptance of deep well submersible pumps: Users should carefully check and accept whether the cable sheath is damaged when picking up goods from the logistics company. Whether the pump is broken. 2. Loading and unloading: Be careful when loading and unloading trucks, so as not to damage the concentricity of the unit or break the cable insulation. 3. Inspection steps before the whole unit goes down the well: A. Dismantle the filter screen, use the crowbar to turn the coupling to rotate flexibly, B put the electric pump upright and fill with clean water, connect the cable connector, soak the connector at the water basin, The value of the resistance of the joint measured to ground (insulation resistance of single finger joint to water) is not less than 500 megohms. C. Place the pump upright and add detergent powder to the pump outlet with a suitable container. At the same time, slightly click the motor start button to carefully observe the direction of the pump. The time should not exceed 2 seconds. Make the consecutive marks.