rubber slurry pump yellow

XIW Single Stage Waste Water and Process Centrifugal Pump

XIW Centrifugal Waste Water and Process Vertical Immersion Pump

Flow Rate Up to 1600m³/hr Head (Pressure)Up to 95m Inlet/Outlet Sizes DN40 to DN300 Operating Temperature Up to 95°C Drive Options Electric Motor

The XIW single stage waste water and process centrifugal vertical immersion pump can be used for many applications in the industrial and domestic markets involving the transfer of waste water, sewage and many other fluids that contain suspended solids or fibrous content. Common applications for this cantilever pump include chemical, energy plants, mining, water treatment, grey water, dewatering.

The centrifugal sump pump head sits at the end of a column and is submerged in the fluid while the motor is dry and situated outside the fluid.

The single stage waste water and process centrifugal vertical immersion pump design has many benefits:

There are several impeller types for this sump pump to suit most applications, these include; closed, non-clog, semi open and vortex.

Capable of high flow rates up to 1600m³/hr and large solids passage capability.

Can be supplied with a column length up to 4m for the most challenging of installations.

The motor is situated outside the fluid allowing higher temperature fluids to be pumped without concern of the motor overheating.

No shaft sealing is required in this cantilever pump, this significantly reduces maintenance costs and eliminates any concerns of seal failure.

The XIW single stage waste water and process vertical centrifugal immersion pump is also available in an ATEX version for handling flammable fluids or being installed in a non-safe area.

Product summary

•Can handle fluids containing suspended solids and fibrous content •No shaft sealing required •Several impeller options including; closed, semi open and vortex •Large solids passage capability •Column length up to 4m •Maximum fluid temperature of 95°C •Available in cast iron, cast steel and other materials upon request •Suction and discharge flanges conform to EN 1092-2 / PN 16. Flanges according to EN 1092-1 / PN 16 for steel and stainless steel casings. If required, ANSI/ASME flanges can be supplied. •Single phase and three phase 50hz / 60hz motors. IP55 as standard. •ATEX version upon request •Independent certification is available upon request •All impellers are balanced according to ISO 1940 class 6.3 •Long coupled with baseplate •Bearings are normally grease lubricated