warman slurry pump brochure pdf

Zoeller 661-0035 Model J661 Sewage Waste Dewatering Non-Clog Pump 7.5

Zoeller J661 Series Sewage & Dewatering Pump Description

The "Sewage-Waste" series of submersible pumps is designed for use in commercial dewatering and wastewater applications and can be used to transfer wastewater or unscreened raw sewage. The semi-open reversing impeller design reduces the risk of clogging and allows each pump to pass a 2½" (63mm) spherical solid. These durable cast iron pumps include a powder coated epoxy finish to prevent corrosion, and are designed to provide great heat dissipation from the motor, ensuring a long service life. As with every Zoeller pump, each one is 100% pressure-tested, submerged and run to ensure quality and reliability for years of trouble-free performance! This attention to detail is an inherent feature in every pump of this series, making it one of the most reliable in the industry.

Zoeller J661 Series Sewage & Dewatering Pump Features and Benefits

Class 30 Cast Iron Construction

All Units are Double Seal for Extra Motor Protection

Corrosion Resistant Powder Coated Epoxy Finish

Stainless Steel Screws, Washers, Tag and Seal Assembly

Oil Filled, Hermetically Sealed Motor with Heavy Duty Finned Motor Housing for Added Heat Dissipation

Continuous Duty Operation in Submerged Conditions

Maximum Temperature for Sewage or Dewatering: 104°F (40°C) with 1.0 Service Factor

416 Stainless Steel Motor Shaft

Stainless Steel Fitted Tandem Shaft Seals, Carbon Ceramic Seal Faces

3” Horizontal Flanged Discharge Discharge

Control Panels with Overload Protection Available

Non-Automatic for Variable Level Control Systems

Zoeller 661-0035 Sewage & Dewatering Pump Specifications

VOLTAGE: 3ø, 200V, 60Hz

HORSEPOWER: 7.5 HP

AMP DRAW (full load): 25.3

MOTOR TYPE: 3 Phase

RPM: 1750

MAXIMUM HEAD: 65'

MAXIMUM CAPACITY: 600 GPM

SWITCH TYPE: Manual

DISCHARGE PIPE SIZE: 3" Horizontal Flange Discharge

MAXIMUM SOLIDS HANDLING SIZE: 2-1/2" Spherical Solid

IMPELLER TYPE: Ductile Iron, Semi-Open

CORD LENGTH: 25' Type UL Listed, 3-Wire Cord

BODY CONSTRUCTION: Cast Iron

MAXIMUM LIQUID TEMPERATURE: 104°F (40C)

DUTY RATING: Continuous Duty

Zoeller Limited Warranty

Zoeller products often carry warranty terms that vary in length based on the product type. Refer to the installation manual for specific warranty term.

Manufacturer warrants, to the purchaser and subsequent owner during the warranty period, every new product to be free from defects in material and workmanship under normal use and service, when properly used and maintained, for a period of three years from the date of purchase. Proof of purchase is required. Parts that fail within the warranty period, that inspections determine to be defective in material or workmanship, will be repaired, replaced or remanufactured at Manufacturer's option, provided however, that by so doing we will not be obligated to replace an entire assembly, the entire mechanism or the complete unit. No allowance will be made for shipping charges, damages, labor or other charges that may occur due to product failure, repair or replacement.

This warranty does not apply to and there shall be no warranty for any material or product that has been disassembled without prior approval of Manufacturer, subjected to misuse, misapplication, neglect, alteration, accident or act of nature; that has not been installed, operated or maintained in accordance with Manufacturer's installation instructions; that has been exposed to outside substances including but not limited to the following: sand, gravel, cement, mud, tar, hydrocarbons, hydrocarbon derivatives (oil, gasoline, solvents, etc.), or other abrasive or corrosive substances, wash towels or feminine sanitary products, etc. in all pumping applications. The warranty set out in the paragraph above is in lieu of all other warranties expressed or implied; and we do not authorize any representative or other person to assume for us any other liability in connection with our products.

Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky 40211, Attention: Customer Service Department to obtain any needed repair or replacement of part(s) or additional information pertaining to our warranty.

MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR SPECIAL, CONSEQUENTIAL OR INCIDENTAL DAMAGES OR BREACH OF EXPRESSED OR IMPLIED WARRANTY; AND ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND OF MERCHANTABILITY SHALL BE LIMITED TO THE DURATION OF THE EXPRESSED WARRANTY.

Some states do not allow limitations on the duration of an implied warranty, so the above limitation may not apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.