y ash slurry pump parts

How To Solve The Blockage Of Slurry Pump?

How to solve the blockage of slurry pump?

How can we solve the problem of blockage found in use? Many customers think that this is a very complex problem, but if this kind of blockage problem is not handled properly, it is easy to cause damage to the equipment, thus affecting the efficiency of use. Therefore, we should pay special attention to it. In fact, if we grasp the following points, we can easily solve the problem.

1. The solid and hard sediment in the volute of horizontal slurry pump makes it clogged, and the measures to remove the clogged matter can be taken.

2. If the axis of the shaft is different from that of the stuffing box, the main reason is large machining error and incorrect installation. Pay attention to check whether the installation is correct after installation. If the Lantern ring is seriously worn, it needs to be replaced. If the flushing water pipe is blocked, the flushing water can not enter the middle of the packing, resulting in rapid wear of the packing and leakage. The blocked water pipe shall be dredged to keep the flushing water clean.

3. If the impeller or inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned. If the impeller is seriously worn, it should be replaced immediately. If there is air leakage at the packing port, the packing shall be compacted. If the conveying height is too high, the loss resistance in the pipe is too large, so the conveying height or resistance should be reduced.

The horizontal slurry pump should be maintained regularly in use, including desilting, so as to effectively avoid the problem of slurry pump blockage. In dealing with this kind of problem, different treatment methods can be selected according to the specific situation of the blockage.