3 inch slurry pump 600 gpm

ZOELLER 105 INSTALLATION INSTRUCTIONS MANUAL Pdf Download

Installation Instructions

Drain pump system

Notice to Installer: Instructions must remain with installation.

Your Peace of Mind is Our Top Priority

Product information presented here reflects conditions at time of publication. Consult factory regarding discrepancies or inconsistencies.

Notice to Installer: Instructions must remain with installation.

1. Inspect your unit. Occasionally, products are damaged during shipment. If the unit is damaged, contact your dealer before using. DO NOT remove the test plugs from the pump.

2. Carefully read the literature provided to familiarize yourself with specific details regarding installation and use. These materials should be retained for future reference.

Warnings

1. To reduce the risk of electrical shock, a properly grounded receptacle of grounding type must be installed and protected by a ground fault circuit interrupter (GFCI) and in accordance with National Electrical Code and local codes.

2. Make certain that the receptacle is within the reach of the pump's power supply cord. DO NOT USE AN EXTENSION CORD. Extension cords that are too long or too light do not deliver sufficient voltage to the pump motor and could present a safety hazard if the insulation were to become damaged or the connection end were to fall into the sump.

3. Testing for Ground. As a safety measure, each electrical outlet should be checked for ground using an Underwriters Laboratory Listed circuit analyzer which will indicate if the power, neutral and ground wires are correctly connected to your outlet. If they are not, call a qualified electrician.

4. For Added Safety. Pump must be connected to a 3-prong grounded outlet interrupter device (ground fault circuit interrupter).

5. FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM ITS POWER SOURCE BEFORE HANDLING. Single phase pumps are supplied with a 3-prong grounded plug to help protect you against the possibility of electrical shock. DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE GROUND PIN. To reduce the risk of electrical shock, a properly grounded receptacle of grounding type must be installed and protected by a ground fault circuit interrupter (GFCI) in accordance with national electrical code and local codes.

6. Installation and checking of electrical circuits and hardware should only be performed by a qualified, licensed electrician.

7. Risk of electric shock - These pumps have not been investigated for use in swimming pool areas.

Cautions

1. Check to be sure your power source is adequate for handling the voltage requirements of the motor, as indicated on the pump or basin plate.

2. Make sure the pump electrical supply circuit is equipped with fuses or circuit breakers of proper capacity. A separate branch circuit is recommended, sized according to the National Electrical Code and local codes for the current shown on the pump name plate.

3. All plumbing (discharge and vent lines) must be installed to meet local codes. Unit must be vented. DO NOT USE AN AUTOMATIC PLUMBING VENT DEVICE SIMILAR TO A "PRO-VENT". Some states require this product to be installed by a licensed plumber.

4. Repair and service should be performed by Zoeller Pump Company Authorized Service Station only.

5. CHECK VALVE MUST BE USED TO REDUCE UNNECESSARY CYCLING OF PUMP.

6. Dewatering pumps are not designed or intended for handling raw sewage.

7. Maximum operating temperature for 105 Drain Pumps must not exceed 54 °C (130 °F).

8. For health reasons, do not unplug, turn off, or disable pump and use pump tank system as a way to fill up a sink or laundry tray, etc.

9. Unit is designed for above ground installation only.

REFER TO WARRANTY ON PAGE 2.