peristaltic pump for slurry

15 hp Vertical Centrifugal Pump

Overview

15 hp vertical centrifugal pump is a non-self-priming centrifugal pump that has a maximum flow of 16.3m3/h (72 gpm), a maximum head of 82m (269ft), and the same diameter of inlet and outlet 50mm (2 inch). The low-price 3-phase centrifugal pump also has optional input voltage AC 240V/ 380V/ 460V to 480V and optional input frequency 50Hz/60Hz. It can be used in pipeline pressurization of production line, cooling tower water feeding, high-rise building pressurized water supply, fire water, and air condition system water supply.

Features:

The centrifugal pump has a vertical structure. The diameter of the inlet and outlet are the same. The inlet and outlet are on the same center line so that the vertical centrifugal pump can be installed in the pipeline like a valve. If a protective cover is added, it can be used in the open air.

It is easy to install and maintain. There is no need to dismantle the pipeline system, just lift off the conjunction flat nut of the vertical pump. Then, all the rotor parts can be taken out.

A vertical centrifugal pump can operate in series or parallel connection according to the requirements of flow and head.

A vertical pump can be installed vertically or horizontally according to the requirement of the pipeline system.

Specifications:

Model ATO-VCP-50-250 Weight 180kg Size 440*430*750mm Power 15 hp (11kW) Phase 3 phase Input voltage AC 220V, 230V, 240V, 380V, 400V, 415V, 440V, 460V, 480V Input frequency 50Hz, 60Hz Flow (min. flow to max. flow)8.8m 3/h (39 gpm, American system)12.5m 3/h (55 gpm, American system)16.3m 3/h (72 gpm, American system) Head (max. head to min. head)82m (269ft)80m (262ft)77.5m (254ft) Efficiency 29%38%40% Inlet diameter 50mm (2 inch) Outlet diameter 50mm (2 inch) Installation mode Vertical type or horizontal type Nominal diameter of impeller 250mm Pump type Booster pump Number of stages Single stage Motor type Y/Y2 series motor Motor speed 2900rpm Impeller material 304/316 stainless steel Seal material 304 stainless steel, tungsten carbide, fluorine rubber Inlet max. pressure 1MPa (145 psi) (NPSH)r 2.3m Usage Water or liquids compatible with pump component materials.

The volume of solid particles should be less than 0.1% in unit volume, and the granularity should be less than 0.2mm.

The temperature should be lower than 60℃. Environment Temperature: ＜40℃, humidity: ＜95%, altitude＜1000m Warranty 12 months

Tips: Centrifugal pump troubleshooting - insufficient flow and head

Possible reason: Air leakage of the water adsorption pipe or bottom valve, blockage of the water inlet, insufficient underwater depth of the bottom valve, too low water pump revolving speed, too serious abrasion of the sealing ring or impeller, not standard sunction height and so on.

Solution: Check the suction pipe and the bottom valve, block the air leakage source. Clean up the silt or blockage at the water inlet, guarantee the depth of the bottom valve be greater than 1.5 times the diameter of the inlet pipe, increase the depth of the bottom valve, check the power supply voltage, increase the centrifugal pump speed, replace the seal ring or impeller, reduce the installation position of the pump, or replace the high head pump.